Design of Machine Elements
102601Module 3: Joints
Q.1(c). The transverse fillet welded joints are designed for (i) Tensile strength (ii) Compressive strength (iii) Bending strength (iv) Shear strength20262m
Module 3: Joints
View this question on its own page →The transverse fillet welded joints are designed for
(i) Tensile strength
(ii) Compressive strength
(iii) Bending strength
(iv) Shear strengthQ.1(d). The resilience of a bolt may be increased by (i) Increasing its shank diameter (ii) Increasing its length (iii) Decreasing its shank diameter (iv) Decreasing its length20262m
Module 3: Joints
View this question on its own page →The resilience of a bolt may be increased by
(i) Increasing its shank diameter
(ii) Increasing its length
(iii) Decreasing its shank diameter
(iv) Decreasing its lengthQ.3(a). Establish the relationship between leg and throat of fillet weld.20267m
Module 3: Joints
View this question on its own page →Establish the relationship between leg and throat of fillet weld.
Q.3(b). A 65 mm diameter solid shaft is to be welded to a flat plate by a fillet weld around the circumference of the shaft. Determine the size of the weld if the torque on the shaft is 3 kN-m. The allowable shear stress in the weld is 70 MPa.20267m
Module 3: Joints
View this question on its own page →A 65 mm diameter solid shaft is to be welded to a flat plate by a fillet weld around the circumference of the shaft. Determine the size of the weld if the torque on the shaft is 3 kN-m. The allowable shear stress in the weld is 70 MPa.
Q.9(a). Write short note on: Caulking and fullering20267m